Installing Overdrive+ on BYD

Enable Wireless ADB Debug

Steps to enable Wireless adb

If you've already enabled adb, skip this step

and go straight to Download & Install

Enable Wireless adb on the Android device
- BYD Firmware that supports enabling adb 2412, 2503, 2507, 2602 , 2606
  Advice for new Firmware versions
  Firmware 2602, 2606 may have issues when using Overdrive+
  This is because newer Firmware restricts adb usage and strengthens system security
Special thanks to Tycherplus

Steps to enable Wireless adb Firmware 2602, 2606

TIP

There are several ways to install; here we'll install using the adb command over a WiFi connection

Connect adb before installing with the command adb connect 192.1.1.2
- Note: the IP 192.1.1.2 is the IP obtained from connecting the BYD car to WiFi; the IP for your installation will not be the same
Verify the connection with the command adb devices

bash

List of devices attached
192.1.1.2:5555 device

Do the initial setup before using. When the installation is done, tap the Overdrive+ app and follow the steps below
Tick the checkbox and press ALLOW
Very important!
Without ALLOW, you won't be able to configure anything

Press Open BYD Auto-Start to configure Disable Autostart
Very important!
Select Disable as shown. If you don't, after a Reboot the app won't be able to start

Select your model and set the battery capacity
- Go to the Dashboard page
- Select your model and enter the battery capacity for your car